Logo

U3660 Engine Code Repair

Meaning of U3660 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U3660 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for U3660 code is occuring now you should check U3660 repair processes.
Now don't ask yourself; What should you do with U3660 code ?
The solution is here :

U3660 Possible Solution:

U3660 Engine

Excessive air inflow can be caused by a vacuum leak, a dirty sensor or, an exhaust gas recirculation valve not closing properly. If the problem is not enough fuel, the culprit may be dirty injectors or fuel filters, a weak fuel pump or a leaky fuel pressure regulator. The lean fuel mix error may be accompanied by rough idling, engine misfires, hesitation during acceleration and overall poor engine performance.

U3660 Code Meaning :

U
OBD-II Diagnostic Network (U) Trouble Code For Engine

3
Ignition System Or Misfire

6
Fuel Composition Sensor Circuit Malfunction

6
Cylinder 1 Injector Circuit Low

0
Reverse Input Circuit

Regarding the U3660 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

U3660 OBD-II Diagnostic Network (U) Trouble Code Description

U3660 engine trouble code is about Reverse Input Circuit.

Main reason For U3660 Code

The reason of U3660 OBD-II Engine Trouble Code is Fuel Composition Sensor Circuit Malfunction.

U3660 DTCs may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.